Category: CONTROLS
-
Magna Q&A 3 – Connecting to BACnet?
Question: How do I set up a Magna 3 to communicate with BACNet controls to my building automation system? Answer For a Magna 3 or any Grundfos smart pump, add a Grundfos BACnet CIM (Communications Interface Module) P/N 96893770. In New England, most of the wholesalers such as Blodgett Supply, F W Webb and The […]
-
HYDRO MPCE – White Paper
-
MPCE Panel – Installations & Operations Manual
-
Magna 3 Q&A- BACNet ON/OFF Option
Question: Can I set up start/stop on a Magna 3 through a BACnet CIM card rather than hard wire directly to the pump? Answer: Yes, the Binary Outputs can be changed to allow Bus on and off control. The BO, 0 sets the control source. Set to “1” to enable control via BUS Control and […]
-
Magna 3 Q&A – BTU Metering via Delta T control?
Question: I run a housing development and want to set up Magna’s for estimating (non-billable) BTU monitoring. Can this be done with these pumps through a Delta T option? Answer: Yes, it can be in Differential Temperature control mode. The pump should piped on the supply side using the built in sensor. It is accomplished […]
-
MAGNA3 – VIDEOS
